Finishing Basement Walls Mike Holmes


Finishing Basement Walls Mike Holmes

Finishing Basement Walls Mike Holmes - There are several approaches to help avoid moisture damage problems at a cellar. The first rule of thumb isn't a dirt basements. Although these are less prevalent in this day in age, it's good to point out this dirt floors not just hold a large amount of moisture but also can give off a number of gases. When constructing a cellar, make sure you have a floor drain with a trap installed at the bottom point of the floor.

Without a floor drain, any water that is spilled inside can't get out. If necessary, install a sump pump and make sure that the sump cover is tightly sealed. Sump pumps are often used where flood due to a high water table might be a problem. Additionally, waterproof the outside of the foundation walls and install a perimeter drainage system. A frequently overlooked problem in basements is moisture that comes out of humidity.

The easiest way to control humidity would be to exhaust water vapor produced in the home to the outside. Indications of high humidity comprise condensation on windows, pipes or other surfaces as well a general sense of moisture from the air, dampness, and smells. Often, the humidity will be brought on by exposing the cellar to external air (open windows), using wet laundry hung to dry from the cellar, keeping firewood from the cellar, or a drier vent that exhausts indoors.

In summer, use a portable dehumidifier or air conditioning to decrease humidity. In hot, humid weather, maintain cellar windows shut. The key to keeping basement humidity would be to keep them well ventilated and keep extra moisture out of the cellar.