Basement Bulkhead Door Plans


Basement Bulkhead Door Plans

Basement Bulkhead Door Plans - There are numerous approaches to help avoid moisture damage problems at a basement. The very first guideline isn't a dirt basements. Though these are less common in this day in age, it's good to point out this dirt floors not only hold a large amount of moisture but can also give off a number of gases. When constructing a basement, make sure you've got a floor drain using a trap installed in the bottom point of the floor.

With no floor drain, any water that's spilled inside can't escape. If needed, install a sump pump and make sure that the sump cover is tightly sealed. Sump pumps are often used where flood due to a high water table might be a problem. In addition, waterproof the outside of the base walls and put in a perimeter drainage system. An often overlooked problem in basements is moisture that comes from humidity.

The easiest way to control humidity would be to exhaust water vapor generated in the house to the outside. Indications of high humidity comprise condensation on walls, pipes or other surfaces as well an overall sense of moisture from the atmosphere, dampness, and smells. Often, the humidity will be caused by exposing the basement to outside air (open windows), using wet laundry hung to dry from the basement, keeping firewood from the basement, or a drier vent that exhausts inside.

To decrease humidity, there are numerous things that a homeowner can perform: install energy-efficient windows, insulate walls and cold water pipes, insulate floors if possible, run drier vents to exhaust directly out and do not dry laundry or firewood on your basement. In summer, use a portable dehumidifier or air conditioning to decrease humidity. In warm, humid weather, keep basement windows closed. The key to maintaining basement humidity low would be to keep them well ventilated and keep additional moisture from the basement.