Finishing A Basement Ceiling

328 views

Finishing A Basement Ceiling


Finishing A Basement Ceiling - There are several approaches to help prevent moisture damage issues at a cellar. The very first rule of thumb is no dirt basements. Although these are somewhat less common in this day in age, it's good to point out that dirt floors not just hold a huge amount of moisture but also can give off a number of gases. When building a cellar, make certain that you've got a floor drain with a trap installed at the bottom point of the floor.

Without a floor drain, any water that's spilled inside cannot escape. If needed, install a sump pump and make sure that the sump cover is tightly sealed. Sump pumps are often used where flood because of a high water table might be a problem. In addition, waterproof the exterior of the base walls and put in a perimeter drainage system. A frequently overlooked problem in bathrooms is moisture that comes from humidity.


The simplest way to control humidity is to exhaust water vapor produced in the home to the exterior. Indications of high humidity comprise condensation on windows, pipes or other surfaces as well a general sense of moisture from the air, dampness, and odors. Many times, the humidity is going to be caused by exposing the cellar to external air (open windows), having wet laundry hung to dry from the cellar, storing firewood from the cellar, and/or a dryer vent that exhausts inside.

To decrease humidity, there are several things a homeowner can perform: install energy-efficient windows, insulate walls and cold water pipes, prefinished flooring if at all possible, run dryer vents to exhaust directly outside and do not dry laundry or firewood in your cellar. In summer, use a portable air conditioner or air conditioning to decrease humidity. In hot, humid weather, maintain cellar windows closed. Run the furnace fan continuously to circulate home air. The real key to keeping basement humidity low is to keep them well ventilated and keep extra moisture from the cellar.