Zenwall Insulated Basement Wall Panels - There are several ways to help avoid moisture damage problems in a basement. The very first rule of thumb is no dirt basements. Though these are somewhat less common in this day in age, it is a good idea to point out this dirt floors not only hold a large amount of moisture but also can give off a number of gases. When building a basement, make certain that you have a floor drain using a trap installed at the bottom point of the floor.
Without a floor drain, any water that is spilled inside can't escape. Sump pumps are usually used where flooding due to a high water table may be a issue. In addition, waterproof the exterior of the base walls and install a perimeter drainage system. An often overlooked problem in basements is moisture that comes out of humidity.
The simplest way to control humidity is to exhaust water vapor generated in the home to the exterior. Signs of high humidity include condensation on walls, pipes or other surfaces as well a general awareness of moisture from the air, dampness, and smells. Many times, the humidity is going to be caused by exposing the basement to outside air (open windows), having wet laundry hung to dry from the basement, keeping firewood from the basement, or a dryer vent that exhausts indoors.
In hot, humid weather, keep basement windows closed. Run the furnace fan continuously to circulate home air. The real key to keeping basement humidity is to keep them well ventilated and to keep additional moisture from the basement.