Ayers Basement Systems Complaints - There are numerous ways to help avoid moisture damage problems in a basement. The first guideline is no dirt basements. Although these are somewhat less common in this day in age, it is good to point out that dirt floors not only hold a huge amount of moisture but also can give off a variety of gases. When building a basement, make sure you have a floor drain using a trap installed at the lowest point of the floor.
Without a floor drain, any water that's spilled inside cannot escape. If needed, install a sump pump and ensure the sump cover is tightly sealed. Sump pumps are often used where flooding because of a high water table might be a problem. Additionally, waterproof the exterior of the foundation walls and put in a perimeter drainage system. An often overlooked problem in basements is moisture that comes from humidity.
The simplest way to control humidity would be to exhaust water vapor produced in the house to the exterior. Signs of high humidity include condensation on walls, pipes or other surfaces as well an overall awareness of moisture from the air, dampness, and smells. Often, the humidity is going to be brought on by exposing the basement to outside air (open windows), having wet laundry hung to dry from the basement, storing firewood from the basement, or a drier vent that exhausts inside.
To reduce humidity, there are numerous things that a homeowner can perform: install energy-efficient windows, insulate walls and cold water pipes, prefinished flooring if at all possible, run drier vents to exhaust straight out and don't dry laundry or firewood in your basement. In hot, humid weather, maintain basement windows shut. The key to maintaining basement humidity low would be to keep them well ventilated and to keep extra moisture out of the basement.